Description
Diamondtred is manufactured from a special blend of P.V.C., silica quartz and polymeric plasticiser giving an homogeneous hard wearing anti-slip flooring for wet and dry conditions. (Meets British Standard for Sheet Vinyl and Vinyl Tiles BS3261:1973).

Residual Indentation
(2.5mm dial gauge) Mean 0.05mm

Dimensional Stability
(80¡C for 6 hours) 0.12%

Moisture Movement
(23¡C for 24 hours) 0.02%

Elastic Property
(Tensile Strength) 2.48mj/m3

Heat Ageing
(70¡C for 15 days) Exudation None, Colour Change None

Wear Resistance - Taber Abrader
1kg load = 1000 revs. H18 wheel @ 60 rpm = 0.6gm Weight Loss

Slip Resistance - AS/NZS 3661.1:1993
Slip Resistance of Pedestrian Surfaces, Part 1 Coefficient of Friction
Dry(Tortus) = 0.80
Wet (Pendulum) = 0.44

Slip Resistance - AS/NZS 4586-1999
Wet Pendulum - mean 46 - class W
Dry Floor - mean 0.80 - class F
Wet/Barefoot ramp - Result 19¼ - class B
Oil- Wet ramp - Result 13.7¼ - class R10

Flammability and Smoke Density
Flame Spread = 0
Smoke Dev = 7
Australian Std Test: 1530.3.1982)

Resistance Properties
Diamondtred is resistant to attack from ultraviolet light, oil, grease, petrol, salt, dilute acids and alkalis, common household chemicals and detergents. Organic solvents will soften Diamondtred.

Maintenance
Diamondtred is produced with a polyurethane coating which reduces dirt retention. The three dimensional pyramid pattern which provides excellent slip resistance in the wet will require more care than a smooth flooring surface. As with any flooring, regular maintenance is important to prevent excessive soiling. Cleaning is best achieved by scrubbing with a bristle brush in conjunction with warm soapy water. Commercial cleaning machines such as the ÒScrub-VacÓ are also suitable.

Installation
When Diamondtred is used as a flooring it should be installed using an adhesive recommended for the under floor and environment. The adhesive manufacturerÕs directions and instructions should be followed closely to ensure maximum bond strength. Diamondtred is heat weldable and can be seamed with PVC liquid weld. For exterior use, or where water may be present, a 2-pack epoxy or polyurethane should be used, again following manufacturerÕs instructions.

Dimensions
Insert widths: 13mm, 25mm, 37mm, 43mm, 53mm.
Tiles: 700mm x 350mm or 300mm x 300mm
Rolls: 350mm x 25m long
Thickness: 3mm
Weight/m2: 4.5kg
Other sizes available on request.