PREPARATION
Before application all surfaces must be clean and free of dust, oil and grease. Adhesion largely depends on careful surface preparation. Try a small area first to satisfy yourself with the final result. All sharp edges should be bevelled.

PREVIOUSLY PAINTED SURFACES
Carefully remove any flaking or cracked paint and follow application directions. If the surface is sound, lightly sand, remove dust and apply as directed.

METALS
Must be clean with all rust neutralised or removed. After preparation apply one coat of Metal Primer allowing adequate drying time before coating with SOFDEX.

TIMBER AND PLYWOOD
Sand smooth, and clean thoroughly. Apply one coat Timber Primer allowing minimum 24 hours drying time before coating with SOFDEX.

CONCRETE SURFACES
Etch the surface with hydro-chloric acid (Spirits of Salts) diluted 1 to 3 with water. Hose down and clean thoroughly.
Allow surface to dry and apply coating of SOFDEX. For old or weathered concrete, remove any trace of grease, oil or dirt, and when thoroughly clean, apply as directed. On very smooth or dusty surfaces we recommend thinning the first coat of SOFDEX 20% with water.

APPLICATION
Fill all surface defects such as holes, joints and cracks with caulking compound. Ensure expansion joints are correctly formed according to building codes. Apply the first coat of SOFDEX with a long pile paint roller or paint brush. Allow to dry thoroughly for minimum six hours or preferably overnight, depending on temperature conditions. (Do not apply below 15 degrees C). After first coat is completely dry apply a second coat at 90¼ or in a right angle direction to the first coat and where applicable apply the third coat at 90¼ or in a right angle direction to the second coat. Each coat should be applied at 5-6 square metres per litre. Allow to dry for a minimum of 24 hours after final coat before subjecting to light traffic. (72 hours minimum for full cure). NOTE: Some rubber compounds may stick to SOFDEX.

TOUCH UP PROCEDURES
Thoroughly wash the area with a detergent solution, hose and allow to dry. When dry, simply overcoat with SOFDEX to restore the original appearance. Clean up with water.